Item: Permanent road stud.

Item No.: KT209

Net Weight: 143g.

Dimension: 100mmx100mmx19mm.

Colour: White, amber, red.

Material: High-class ABS housing and polymethyl methacrylate (PMMA) lens reflector.

Compressive strength: 16 tons.

Installation: bitumen, epoxy resin or butyl rubber.

Package: 100pcs/carton,

Carton size: 56x56x23cm,G.W.:11kgs.

Regulation: EN1463-1 and ASTM D 4280.

Circumstance: -20°C - 80°C.

Requires a 12mm x 65mm hole for installation

The K-LITE reflecting road studs KT209 is a permanent road stud that can use on all road surfaces. The combination of an advanced optical design and computer-aided construction design has resulted in a highly visible, long-lasting system that offers high performance.

The reflector lens offer high visibility in wet and dry weather, day and night conditions. With bright retro-reflected light when illuminated by car headlights, exceeding 1.5 times than requirements of BS EN1463-1.

Strong construction guarantee long-lasting performance, KT209 manufactured from a high impact resistant polycarbonate resin, the inner crossed ribbed contour of the stud is shaped to increase strength and reduce damage.

The polymethyl methacrylate (PMMA) lens with inner ribs patterns ensures the strength of lens reflector.

Installation method

1. Ensure your work environment is safe and measures are in place to keep traffic away from your work crew and ensure the safety of yourself and your workers

2. Identify and mark installation position, ensure installation position is according to the road authority standards, improper placement of road studs can cause confusion to drivers and lead to accidents

3. Drill hole in asphalt on marked position 12mm dia x 65mm deep

4. Ensure hole is clean and dry and free of any debris, any obstruction in the hole will hamper the proper and secure installation of the road stud, any oil or other chemicals on the road surface with prevent epoxy resin glue from adhering properly

5. Mix two part epoxy resin glue and place enough epoxy onto hole, push shank of stud through epoxy glue into hole ensuring enough epoxy to completely cover underside of stud and secure the shank in the hole, always use gloves when working with epoxy resin

6. Align the stud properly so lens face oncoming traffic, wrong alignment of the road stud will look real bad and minimize the effectiveness of the retro reflective lens

7. Scrape away any extra epoxy glue and return to glue pot for later use, take care not to get any epoxy glue onto stud lens

8. Inspect Installation to ensure quality workmanship

9. Protect stud from traffic until epoxy glue is dry, this will take about one hour depending on the ambient temperature and type of epoxy glue used

10. Always: Work safe, Work accurate, Work fast